| Message ID | 20200213025930.27943-1-jaedon.shin@gmail.com |
|---|---|
| Headers | show |
| Series | PCI: brcmstb: Add Broadcom STB support | expand |
+Jim, On 2/12/2020 6:59 PM, Jaedon Shin wrote: > This series enables the ARM based Broadcom STB SoCs and supports GPIO > based regulators for its power supplies. and this has an improvement on > devm_ APIS. Which ARM-based SoCs did you try this on? We still have an issue with the multiple dma-ranges that must be handled to support 7445 with memory in the extension regions as well as 7278 and 7216. See comments in specific patches. > > Jaedon Shin (3): > PCI: brcmstb: Enable ARCH_BRCMSTB > PCI: brcmstb: Add regulator support > PCI: brcmstb: Drop clk_put when probe fails and remove > > .../bindings/pci/brcm,stb-pcie.yaml | 8 +- > drivers/gpio/gpio-brcmstb.c | 13 +++- > drivers/pci/controller/Kconfig | 2 +- > drivers/pci/controller/pcie-brcmstb.c | 78 ++++++++++++++++++- > 4 files changed, 97 insertions(+), 4 deletions(-) >
> 2020. 2. 13. 오후 12:54, Florian Fainelli <f.fainelli@gmail.com> 작성: > > +Jim, > > On 2/12/2020 6:59 PM, Jaedon Shin wrote: >> This series enables the ARM based Broadcom STB SoCs and supports GPIO >> based regulators for its power supplies. and this has an improvement on >> devm_ APIS. > > Which ARM-based SoCs did you try this on? We still have an issue with > the multiple dma-ranges that must be handled to support 7445 with memory > in the extension regions as well as 7278 and 7216. I'm using BCM72604 which has only one memc. and device is Qualcomm Atheros QCA6174 Wi-Fi module. > > See comments in specific patches. > >> >> Jaedon Shin (3): >> PCI: brcmstb: Enable ARCH_BRCMSTB >> PCI: brcmstb: Add regulator support >> PCI: brcmstb: Drop clk_put when probe fails and remove >> >> .../bindings/pci/brcm,stb-pcie.yaml | 8 +- >> drivers/gpio/gpio-brcmstb.c | 13 +++- >> drivers/pci/controller/Kconfig | 2 +- >> drivers/pci/controller/pcie-brcmstb.c | 78 ++++++++++++++++++- >> 4 files changed, 97 insertions(+), 4 deletions(-) >> > > -- > Florian
On Thu, Feb 13, 2020 at 12:15 AM Jaedon Shin <jaedon.shin@gmail.com> wrote: > > > > 2020. 2. 13. 오후 12:54, Florian Fainelli <f.fainelli@gmail.com> 작성: > > > > +Jim, > > > > On 2/12/2020 6:59 PM, Jaedon Shin wrote: > >> This series enables the ARM based Broadcom STB SoCs and supports GPIO > >> based regulators for its power supplies. and this has an improvement on > >> devm_ APIS. > > > > Which ARM-based SoCs did you try this on? We still have an issue with > > the multiple dma-ranges that must be handled to support 7445 with memory > > in the extension regions as well as 7278 and 7216. > > > I'm using BCM72604 which has only one memc. and device is Qualcomm Atheros > QCA6174 Wi-Fi module. > You apparently have a simple enough memory configuration such that the current upstream driver will work. But this will not work for a 7445-based chip or other BCM7xxx chips that either have a memory region extension or a non-zero system memory offset. IIRC, similar regulator code was submitted before as part of the complete driver that could handle our curious DMA situation, but was rejected because someone objected to us using a generic list of regulators without specific explanation for each in the device tree documentations. I hope you have better luck :-) Thanks, Jim > > > > See comments in specific patches. > > > >> > >> Jaedon Shin (3): > >> PCI: brcmstb: Enable ARCH_BRCMSTB > >> PCI: brcmstb: Add regulator support > >> PCI: brcmstb: Drop clk_put when probe fails and remove > >> > >> .../bindings/pci/brcm,stb-pcie.yaml | 8 +- > >> drivers/gpio/gpio-brcmstb.c | 13 +++- > >> drivers/pci/controller/Kconfig | 2 +- > >> drivers/pci/controller/pcie-brcmstb.c | 78 ++++++++++++++++++- > >> 4 files changed, 97 insertions(+), 4 deletions(-) > >> > > > > -- > > Florian >
> 2020. 2. 14. 오전 12:54, Jim Quinlan <james.quinlan@Broadcom.com> 작성: > > On Thu, Feb 13, 2020 at 12:15 AM Jaedon Shin <jaedon.shin@gmail.com> wrote: >> >> >>> 2020. 2. 13. 오후 12:54, Florian Fainelli <f.fainelli@gmail.com> 작성: >>> >>> +Jim, >>> >>> On 2/12/2020 6:59 PM, Jaedon Shin wrote: >>>> This series enables the ARM based Broadcom STB SoCs and supports GPIO >>>> based regulators for its power supplies. and this has an improvement on >>>> devm_ APIS. >>> >>> Which ARM-based SoCs did you try this on? We still have an issue with >>> the multiple dma-ranges that must be handled to support 7445 with memory >>> in the extension regions as well as 7278 and 7216. >> >> >> I'm using BCM72604 which has only one memc. and device is Qualcomm Atheros >> QCA6174 Wi-Fi module. >> > You apparently have a simple enough memory configuration such that the > current upstream driver will work. But this will not work for a > 7445-based chip or other BCM7xxx chips that either have a memory > region extension or a non-zero system memory offset. I fully agree. It's not yet ready to enable ARM based BCM7445 SoCs. We'd better not add ARCH_BRCMSTB and "brcm,bcm7445-pcie" string until the multi dma- range problem is solved. > > IIRC, similar regulator code was submitted before as part of the > complete driver that could handle our curious DMA situation, but was > rejected because someone objected to us using a generic list of > regulators without specific explanation for each in the device tree > documentations. I hope you have better luck :-) I'll refer to. Thanks, Jaedon > > Thanks, > Jim >>> >>> See comments in specific patches. >>> >>>> >>>> Jaedon Shin (3): >>>> PCI: brcmstb: Enable ARCH_BRCMSTB >>>> PCI: brcmstb: Add regulator support >>>> PCI: brcmstb: Drop clk_put when probe fails and remove >>>> >>>> .../bindings/pci/brcm,stb-pcie.yaml | 8 +- >>>> drivers/gpio/gpio-brcmstb.c | 13 +++- >>>> drivers/pci/controller/Kconfig | 2 +- >>>> drivers/pci/controller/pcie-brcmstb.c | 78 ++++++++++++++++++- >>>> 4 files changed, 97 insertions(+), 4 deletions(-) >>>> >>> >>> -- >>> Florian