@@ -1,10 +1,19 @@
* NXP PCA954x I2C bus switch
+The driver supports NXP PCA954x and PCA984x I2C mux/switch devices.
+
Required Properties:
- compatible: Must contain one of the following.
- "nxp,pca9540", "nxp,pca9542", "nxp,pca9543", "nxp,pca9544",
- "nxp,pca9545", "nxp,pca9546", "nxp,pca9547", "nxp,pca9548"
+ "nxp,pca9540",
+ "nxp,pca9542",
+ "nxp,pca9543",
+ "nxp,pca9544",
+ "nxp,pca9545",
+ "nxp,pca9546", "nxp,pca9846",
+ "nxp,pca9547", "nxp,pca9847",
+ "nxp,pca9548", "nxp,pca9848",
+ "nxp,pca9849"
- reg: The I2C address of the device.
@@ -64,11 +64,11 @@ config I2C_MUX_PCA9541
will be called i2c-mux-pca9541.
config I2C_MUX_PCA954x
- tristate "Philips PCA954x I2C Mux/switches"
+ tristate "NXP PCA954x and PCA984x I2C Mux/switches"
depends on GPIOLIB || COMPILE_TEST
help
- If you say yes here you get support for the Philips PCA954x
- I2C mux/switch devices.
+ If you say yes here you get support for the NXP PCA954x
+ and PCA984x I2C mux/switch devices.
This driver can also be built as a module. If so, the module
will be called i2c-mux-pca954x.
@@ -4,11 +4,11 @@
* Copyright (c) 2008-2009 Rodolfo Giometti <giometti@linux.it>
* Copyright (c) 2008-2009 Eurotech S.p.A. <info@eurotech.it>
*
- * This module supports the PCA954x series of I2C multiplexer/switch chips
- * made by Philips Semiconductors.
+ * This module supports the PCA954x and PCA954x series of I2C multiplexer/switch
+ * chips made by NXP Semiconductors.
* This includes the:
- * PCA9540, PCA9542, PCA9543, PCA9544, PCA9545, PCA9546, PCA9547
- * and PCA9548.
+ * PCA9540, PCA9542, PCA9543, PCA9544, PCA9545, PCA9546, PCA9547,
+ * PCA9548, PCA9846, PCA9847, PCA9848 and PCA9849.
*
* These chips are all controlled via the I2C bus itself, and all have a
* single 8-bit register. The upstream "parent" bus fans out to two,
@@ -63,6 +63,10 @@ enum pca_type {
pca_9546,
pca_9547,
pca_9548,
+ pca_9846,
+ pca_9847,
+ pca_9848,
+ pca_9849,
};
struct chip_desc {
@@ -129,6 +133,24 @@ static const struct chip_desc chips[] = {
.nchans = 8,
.muxtype = pca954x_isswi,
},
+ [pca_9846] = {
+ .nchans = 4,
+ .muxtype = pca954x_isswi,
+ },
+ [pca_9847] = {
+ .nchans = 8,
+ .enable = 0x8,
+ .muxtype = pca954x_ismux,
+ },
+ [pca_9848] = {
+ .nchans = 8,
+ .muxtype = pca954x_isswi,
+ },
+ [pca_9849] = {
+ .nchans = 4,
+ .enable = 0x4,
+ .muxtype = pca954x_ismux,
+ },
};
static const struct i2c_device_id pca954x_id[] = {
@@ -140,6 +162,10 @@ static const struct i2c_device_id pca954x_id[] = {
{ "pca9546", pca_9546 },
{ "pca9547", pca_9547 },
{ "pca9548", pca_9548 },
+ { "pca9846", pca_9846 },
+ { "pca9847", pca_9847 },
+ { "pca9848", pca_9848 },
+ { "pca9849", pca_9849 },
{ }
};
MODULE_DEVICE_TABLE(i2c, pca954x_id);
@@ -154,6 +180,10 @@ static const struct of_device_id pca954x_of_match[] = {
{ .compatible = "nxp,pca9546", .data = &chips[pca_9546] },
{ .compatible = "nxp,pca9547", .data = &chips[pca_9547] },
{ .compatible = "nxp,pca9548", .data = &chips[pca_9548] },
+ { .compatible = "nxp,pca9846", .data = &chips[pca_9846] },
+ { .compatible = "nxp,pca9847", .data = &chips[pca_9847] },
+ { .compatible = "nxp,pca9848", .data = &chips[pca_9848] },
+ { .compatible = "nxp,pca9849", .data = &chips[pca_9849] },
{}
};
MODULE_DEVICE_TABLE(of, pca954x_of_match);
This patch extends the current i2c-mux-pca954x driver and adds support for a newer PCA984x family of the I2C switches and multiplexers from NXP. Signed-off-by: Adrian Fiergolski <adrian.fiergolski@cern.ch> --- Following Rob's and Peter's remarks, bindings contain now one valid combination of compatibles per line. .../devicetree/bindings/i2c/i2c-mux-pca954x.txt | 13 ++++++-- drivers/i2c/muxes/Kconfig | 6 ++-- drivers/i2c/muxes/i2c-mux-pca954x.c | 38 +++++++++++++++++++--- 3 files changed, 48 insertions(+), 9 deletions(-)