@@ -38,7 +38,7 @@
* Tx descriptors that can be associated with each corresponding FIFO.
* intr_type: This defines the type of interrupt. The values can be 0(INTA),
* 2(MSI_X). Default value is '2(MSI_X)'
- * lro_enable: Specifies whether to enable Large Receive Offload (LRO) or not.
+ * lro: Specifies whether to enable Large Receive Offload (LRO) or not.
* Possible values '1' for enable '0' for disable. Default is '0'
* lro_max_pkts: This parameter defines maximum number of packets can be
* aggregated as a single large packet
@@ -90,7 +90,7 @@
#include "s2io.h"
#include "s2io-regs.h"
-#define DRV_VERSION "2.0.26.25"
+#define DRV_VERSION "2.0.26.26"
/* S2io Driver name & version. */
static char s2io_driver_name[] = "Neterion";
@@ -496,7 +496,7 @@ S2IO_PARM_INT(rxsync_frequency, 3);
/* Interrupt type. Values can be 0(INTA), 2(MSI_X) */
S2IO_PARM_INT(intr_type, 2);
/* Large receive offload feature */
-static unsigned int lro_enable;
+static unsigned int lro_enable = 1;
module_param_named(lro, lro_enable, uint, 0);
/* Max pkts to be aggregated by LRO at one time. If not specified,
@@ -795,7 +795,6 @@ static int init_shared_mem(struct s2io_nic *nic)
ring->rx_curr_put_info.ring_len = rx_cfg->num_rxd - 1;
ring->nic = nic;
ring->ring_no = i;
- ring->lro = lro_enable;
blk_cnt = rx_cfg->num_rxd / (rxd_count[nic->rxd_mode] + 1);
/* Allocating all the Rx blocks */
@@ -6675,6 +6674,7 @@ static u32 s2io_ethtool_op_get_tso(struct net_device *dev)
{
return (dev->features & NETIF_F_TSO) != 0;
}
+
static int s2io_ethtool_op_set_tso(struct net_device *dev, u32 data)
{
if (data)
@@ -6685,6 +6685,42 @@ static int s2io_ethtool_op_set_tso(struct net_device *dev, u32 data)
return 0;
}
+static int s2io_ethtool_set_flags(struct net_device *dev, u32 data)
+{
+ struct s2io_nic *sp = netdev_priv(dev);
+ int rc = 0;
+ int changed = 0;
+
+ if (data & ~ETH_FLAG_LRO)
+ return -EOPNOTSUPP;
+
+ if (data & ETH_FLAG_LRO) {
+ if (lro_enable) {
+ if (!(dev->features & NETIF_F_LRO)) {
+ dev->features |= NETIF_F_LRO;
+ changed = 1;
+ }
+ } else
+ rc = -EINVAL;
+ } else if (dev->features & NETIF_F_LRO) {
+ dev->features &= ~NETIF_F_LRO;
+ changed = 1;
+ }
+
+ if (changed && netif_running(dev)) {
+ s2io_stop_all_tx_queue(sp);
+ s2io_card_down(sp);
+ sp->lro = !!(dev->features & NETIF_F_LRO);
+ rc = s2io_card_up(sp);
+ if (rc)
+ s2io_reset(sp);
+ else
+ s2io_start_all_tx_queue(sp);
+ }
+
+ return rc;
+}
+
static const struct ethtool_ops netdev_ethtool_ops = {
.get_settings = s2io_ethtool_gset,
.set_settings = s2io_ethtool_sset,
@@ -6701,6 +6737,8 @@ static const struct ethtool_ops netdev_ethtool_ops = {
.get_rx_csum = s2io_ethtool_get_rx_csum,
.set_rx_csum = s2io_ethtool_set_rx_csum,
.set_tx_csum = s2io_ethtool_op_set_tx_csum,
+ .set_flags = s2io_ethtool_set_flags,
+ .get_flags = ethtool_op_get_flags,
.set_sg = ethtool_op_set_sg,
.get_tso = s2io_ethtool_op_get_tso,
.set_tso = s2io_ethtool_op_set_tso,
@@ -7229,6 +7267,7 @@ static int s2io_card_up(struct s2io_nic *sp)
struct ring_info *ring = &mac_control->rings[i];
ring->mtu = dev->mtu;
+ ring->lro = sp->lro;
ret = fill_rx_buffers(sp, ring, 1);
if (ret) {
DBG_PRINT(ERR_DBG, "%s: Out of memory in Open\n",
@@ -7974,7 +8013,8 @@ s2io_init_nic(struct pci_dev *pdev, const struct pci_device_id *pre)
dev->netdev_ops = &s2io_netdev_ops;
SET_ETHTOOL_OPS(dev, &netdev_ethtool_ops);
dev->features |= NETIF_F_HW_VLAN_TX | NETIF_F_HW_VLAN_RX;
-
+ if (lro_enable)
+ dev->features |= NETIF_F_LRO;
dev->features |= NETIF_F_SG | NETIF_F_IP_CSUM;
if (sp->high_dma_flag == true)
dev->features |= NETIF_F_HIGHDMA;